Do polyaluminium chloride and anionic polyacrylamide water treatment residuals adsorb phosphorus?

Polyaluminium chloride and anionic polyacrylamide water treatment residuals (PAC-APAM WTRs) as an amendment in three types of soils with the ratios (w/w) of 10%, 15%, and 20% were evaluated for phosphorus adsorption from aqueous solutions by batch studies.

Can anionic polyacrylamide be used as a coagulant in water treatment sludge?

Also, using anionic polyacrylamide (APAM) as a coagulant in the dewatering process of water treatment sludge has been a regular practice to accelerate the dewatering process and decrease the size of dewatering tanks or ponds in large-scale drinking water treatment plants.

Can polyaluminium chloride and anionic polyacrylamide remove CD 2+ and Zn 2+?

Water treatment residuals produced after addition of polyaluminium chloride and anionic polyacrylamide (PAC-APAM WTRs) were evaluated for the potential to remove Cd 2+ and Zn 2+ from aqueous solutions by batch adsorption studies.

Why is polyaluminum chloride a good coagulant for water treatment?

Polyaluminum chloride (PAC) is highly effective coagulant for water treatment over conventional coagulants because of low dosage requirement, shorter flocculation time, smaller amount of sludge, high efficiency and low aluminum residual in treated water .

What is anionic polyacrylamide (PAM)?

Anionic polyacrylamide (PAM) possesses interconnected and active groups that establish robust bonds with the surface of suspended colloids, promoting the formation of coarse particles among the suspended solids and a mixture of insoluble particles in water (Irfan et al. 2017).

What is the coagulant dosage of polyaluminium chloride?

of coagulant dosage could be studied. 150 mg/L (half optimum dosage value) polyaluminium chloride was added to biodiesel wastewater. After rapid mixing for 4 min at 150 rpm different concentrations (2, 4, 6, 8 and 10 mg/L) of polyelectrolyte were added and the liquid was mixed slowly for