Why is polyaluminum chloride a good coagulant for water treatment?

Polyaluminum chloride (PAC) is highly effective coagulant for water treatment over conventional coagulants because of low dosage requirement, shorter flocculation time, smaller amount of sludge, high efficiency and low aluminum residual in treated water .

Does polyaluminium chloride coagulant affect the structure and diversity of pollutants?

The polyaluminium chloride (PAC) coagulant was applied to determine the impact of the treatment process on the structure and diversity of these pollutants in urban drinking water.

Is polyaluminium chloride better than polyelectrolyte – alum-based coagulation?

At the Barekese Water Treatment Plant in Ghana, an alternative, the polyelectrolyte – polyaluminium chloride (PAC) is also used in coagulation but limited information is available on the operating conditions required to achieve better performance than alum-based coagulation.

What is high-purity poly-aluminum chloride (PACL)?

Poly-aluminum chloride (PACl) is one of the common coagulants for water and wastewater treatment. A new Chinese national standard of PACl has been implemented, where the concentration of insoluble substances, iron and heavy metals is to be controlled strictly, then researches on the preparation of high–purity PACl are needed.

How should coagulation pH be matched to raw water alkalinity?

PACl basicity should be matched to raw water alkalinity, so that coagulation pH is as close as possible to the pH of minimum solubility of the coagulant. The solids separation process used for treatment was also found to be important for coagulant selection.

What is the coagulation time for aluminum sulfate and aluminum chloride coagulants?

However, for aluminum sulfate and aluminum chloride coagulants the coagulation time and settling time were reached to 15 and 35 min, respectively. The results revealed that the residual aluminum concentration in the treated water was very small for synthesized PAC coagulant which was <0.2 mg L −1.