Why is polyaluminum chloride a good coagulant for water treatment?

Polyaluminum chloride (PAC) is highly effective coagulant for water treatment over conventional coagulants because of low dosage requirement, shorter flocculation time, smaller amount of sludge, high efficiency and low aluminum residual in treated water .

What is polyaluminium chloride used for?

Polyaluminium chloride (aluminium chlorohydrate) also simply called PAC, is used in deodorants and as a coagulant in water purification. This compound is preferred in some cases because of its high charge, which makes it more effective at destabilizing and removing suspended materials than other aluminium salts. CAS No.: 1327-41-9

Why is PAC used as flocculant?

This compound is preferred in some cases because of its high charge, which makes it more effective at destabilizing and removing suspended materials than other aluminium salts. CAS No.: 1327-41-9 Using PAC as flocculant, the speed of flocs forming and settling is quick. Flocs formed is easy to filter

What is the most effective dosage for polyaluminum chloride (PAC) & aluminum sulfate (FEC?

The findings revealed that the most effective dosages for polyaluminum chloride (PAC), aluminum sulfate (Al 2 (SO 4) 3), and ferric chloride (FeCl 3) were 20, 10, and 20 mg/L, respectively.

Is Pac better than aluminium sulfate flocculant?

Comparing to aluminium sulfate flocculant, the quality of water treated with PAC is better; the total cost reduced by 15%~30%, and the solubility is better. It can be applied to water with broad pH range. The floc function valid in water of pH 5 to pH 9

Can PAC be used as coagulant for water treatment?

The ZPD value of PAC was also revealed that the flocculation tendency of PAC particles was very high in water, and the PAC could be used as coagulant for water treatment. Fig. 5.