Can anionic polyacrylamide be used as coagulant aid with ferric sulphate and polyaluminium chloride?

It is important to point out that the optimal coagulant dose can be reduced when anionic polyacrylamide is used as coagulant aid with ferric sulphate and polyaluminium chloride, thus decreasing treatment costs. 3.10. Mechanisms of the process

Why is polyaluminum chloride a good coagulant for water treatment?

Polyaluminum chloride (PAC) is highly effective coagulant for water treatment over conventional coagulants because of low dosage requirement, shorter flocculation time, smaller amount of sludge, high efficiency and low aluminum residual in treated water .

Does anionic polyacrylamide improve the coagulation–flocculation process?

The use of anionic polyacrylamide had little effect on this cost but improved the coagulation–flocculation process, leading to a significant increase in the settling speed and reduction in the volume of sludge produced. Table 7.

What is the most effective dosage for polyaluminum chloride (PAC) & aluminum sulfate (FEC?

The findings revealed that the most effective dosages for polyaluminum chloride (PAC), aluminum sulfate (Al 2 (SO 4) 3), and ferric chloride (FeCl 3) were 20, 10, and 20 mg/L, respectively.

Can PAC be used as coagulant for water treatment?

The ZPD value of PAC was also revealed that the flocculation tendency of PAC particles was very high in water, and the PAC could be used as coagulant for water treatment. Fig. 5.

Can polymeric PAC be used for water treatment?

Several researchers have investigated the synthesis, of PAC and its performance for water treatment. The results shows that various polymeric species of PAC yield (Al b species) are obtained and different performance efficiencies for water treatment are reported in the literature [21, 24].