What is high-purity poly-aluminum chloride (PACL)?

Poly-aluminum chloride (PACl) is one of the common coagulants for water and wastewater treatment. A new Chinese national standard of PACl has been implemented, where the concentration of insoluble substances, iron and heavy metals is to be controlled strictly, then researches on the preparation of high–purity PACl are needed.

Why is polyaluminum chloride a good coagulant for water treatment?

Polyaluminum chloride (PAC) is highly effective coagulant for water treatment over conventional coagulants because of low dosage requirement, shorter flocculation time, smaller amount of sludge, high efficiency and low aluminum residual in treated water .

What is polyaluminium chloride used for?

Polyaluminium chloride (aluminium chlorohydrate) also simply called PAC, is used in deodorants and as a coagulant in water purification. This compound is preferred in some cases because of its high charge, which makes it more effective at destabilizing and removing suspended materials than other aluminium salts. CAS No.: 1327-41-9

Is Pac better than aluminum sulfate & aluminum chloride for removing turbidity & nom?

Moreover, the performance of synthesized PAC was also very much higher as compared with aluminum sulfate and aluminum chloride for removing turbidity and NOM from synthetic water samples. The coagulant dose and the lime required of synthesized PAC were reduced more than two folds relative to aluminum sulfate and aluminum chloride doses.

What is the difference between high-purity PACL and conventional PACL?

The preparation process of high-purity PACl and conventional PACl is different as stated previously, where raw materials used and the operating conditions are different. As shown in Table 5, Al (OH) 3 is relatively expensive than bauxite but sulfydryl/PAM polymer is cheaper.

Does high-purity PACL reduce operating cost?

On the other hand, when the dose was greater than 4 mg L −1 as Al, the high-purity PACl showed great UV 254 -absorbance removal capacity; which was even much greater at high does (e.g., 10 mg L −1). Relative low dose requirement of high-purity PACl indicates the potential of the reduction of operating cost.