Can poly aluminum chloride and alum be used as a coagulant?

In this study, a novel approach was followed by recycling Poly aluminum chloride (PACl) and Alum as a catalyst for the first time in the catalytic ozonation treatment process leading to a nascent method after using them as a coagulant in Coagulation/Flocculation.

Why is polyaluminum chloride a good coagulant for water treatment?

Polyaluminum chloride (PAC) is highly effective coagulant for water treatment over conventional coagulants because of low dosage requirement, shorter flocculation time, smaller amount of sludge, high efficiency and low aluminum residual in treated water .

Is Pac better than aluminum sulfate & aluminum chloride for removing turbidity & nom?

Moreover, the performance of synthesized PAC was also very much higher as compared with aluminum sulfate and aluminum chloride for removing turbidity and NOM from synthetic water samples. The coagulant dose and the lime required of synthesized PAC were reduced more than two folds relative to aluminum sulfate and aluminum chloride doses.

What is the optimum pH value for processing tannery waste?

The optimum pH value for processing tannery waste with PAC coagulant is pH 8. The dose of PAC in reducing turbidity was greatest at a dose of 125 ppm. The effectiveness of 125 ppm PAC can reduce BOD 32.44 %, COD 12.23%, chrome 94.86%, TSS 91.62%.

Can polymeric PAC be used for water treatment?

Several researchers have investigated the synthesis, of PAC and its performance for water treatment. The results shows that various polymeric species of PAC yield (Al b species) are obtained and different performance efficiencies for water treatment are reported in the literature [21, 24].

Can PAC be used as coagulant for water treatment?

The ZPD value of PAC was also revealed that the flocculation tendency of PAC particles was very high in water, and the PAC could be used as coagulant for water treatment. Fig. 5.