Why is polyaluminum chloride a good coagulant for water treatment?

Polyaluminum chloride (PAC) is highly effective coagulant for water treatment over conventional coagulants because of low dosage requirement, shorter flocculation time, smaller amount of sludge, high efficiency and low aluminum residual in treated water .

What is high-purity poly-aluminum chloride (PACL)?

Poly-aluminum chloride (PACl) is one of the common coagulants for water and wastewater treatment. A new Chinese national standard of PACl has been implemented, where the concentration of insoluble substances, iron and heavy metals is to be controlled strictly, then researches on the preparation of high-purity PACl are needed.

Does polyaluminum chloride remove turbidity?

The study compares the efficacy of polyaluminum chloride and polyacrylamide in removing turbidity, representing the number of suspended solids, under varying pH, mixing time, temperature, oil, and suspended solids conditions. Optimizing these parameters is crucial for enhancing the coagulation treatment’s efficiency.

How does polymeric aluminum chloride achieve destabilization?

Polymeric aluminum chloride (PAC) achieves the destabilization process by adsorbing onto the surface of colloidal particles and facilitating bridging. Consequently, when PAC executes both destabilization mechanisms concurrently, the process becomes more rapid and results in superior separation.

Is Pac better than aluminum sulfate & aluminum chloride for removing turbidity & nom?

Moreover, the performance of synthesized PAC was also very much higher as compared with aluminum sulfate and aluminum chloride for removing turbidity and NOM from synthetic water samples. The coagulant dose and the lime required of synthesized PAC were reduced more than two folds relative to aluminum sulfate and aluminum chloride doses.

What is anionic polyacrylamide (PAM)?

Anionic polyacrylamide (PAM) possesses interconnected and active groups that establish robust bonds with the surface of suspended colloids, promoting the formation of coarse particles among the suspended solids and a mixture of insoluble particles in water (Irfan et al. 2017).