Why is polyaluminum chloride a good coagulant for water treatment?

Polyaluminum chloride (PAC) is highly effective coagulant for water treatment over conventional coagulants because of low dosage requirement, shorter flocculation time, smaller amount of sludge, high efficiency and low aluminum residual in treated water .

What is the performance of synthesized PAC compared with aluminum sulfate?

The performance of synthesized PAC compared with aluminum sulfate, aluminum chloride and commercial PAC for water treatment. 4. Conclusion The synthesis of PΑC results revealed that the low concentration of aluminum chloride favored to the formation of Αl b species of PΑC and the high concentration preferred to the formation of Αl c species of PΑC.

Is Pac better than aluminum sulfate & aluminum chloride for removing turbidity & nom?

Moreover, the performance of synthesized PAC was also very much higher as compared with aluminum sulfate and aluminum chloride for removing turbidity and NOM from synthetic water samples. The coagulant dose and the lime required of synthesized PAC were reduced more than two folds relative to aluminum sulfate and aluminum chloride doses.

Can PAC be used as coagulant for water treatment?

The ZPD value of PAC was also revealed that the flocculation tendency of PAC particles was very high in water, and the PAC could be used as coagulant for water treatment. Fig. 5.

Can PAC be prepared from aluminum chloride solution?

PAC can be prepared from aluminum chloride solution with the titration of various basification agents such as calcium oxide [16, 21], sodium hydroxide [, , ] and sodium aluminate .

Does polyaluminum chloride coagulate with hydrolyzed coagulants?

Coagulation with hydrolyzing coagulants has been studied thoroughly, but the coagulation behavior of pre-hydrolyzed coagulants such as polyaluminum chloride (PACl), especially the coagulation mechanisms at various coagulant dosages and pH values of raw water, has not been systemically investigated and not been well understood , .