Why is polyaluminum chloride a good coagulant for water treatment?

Polyaluminum chloride (PAC) is highly effective coagulant for water treatment over conventional coagulants because of low dosage requirement, shorter flocculation time, smaller amount of sludge, high efficiency and low aluminum residual in treated water .

Is Pac better than aluminum sulfate & aluminum chloride for removing turbidity & nom?

Moreover, the performance of synthesized PAC was also very much higher as compared with aluminum sulfate and aluminum chloride for removing turbidity and NOM from synthetic water samples. The coagulant dose and the lime required of synthesized PAC were reduced more than two folds relative to aluminum sulfate and aluminum chloride doses.

Can PAC be prepared from aluminum chloride solution?

PAC can be prepared from aluminum chloride solution with the titration of various basification agents such as calcium oxide [16, 21], sodium hydroxide [, , ] and sodium aluminate .

What is the optimum yield of medium polymeric (Al B) in PC species?

The optimum yield of medium polymeric (Al b) content in PΑC species was predicted to 74.6 %, and the verification experiment result was 73.5 % at 0.5 M, 2.2, 75 °C and 273 min.

How is monomeric aluminum chloride (hexahydrate form) extracted from Ethiopian kaolinite?

The monomeric aluminum chloride (hexahydrate form) was extracted from Ethiopian kaolinite using hydrochloric acid and its purity was >98 % . The PAC samples were synthesized from extracted aluminum chloride solutions using calcium oxide (90 %, Blulux Laboratories Private Limited, India) as basification agent.

How is PAFC synthesized?

PAFC was synthesized following two steps: First, 50 g of blast furnace dust was placed in a 500 mL three-necked round bottom flask equipped with stirrer and reflux device. Then, 2 g NaF, 150 mL of HCl diluted solution (36%, freshly diluted 1:1 with ultrapure water) and 5 mL of HNO 3 were added.