Why is polyaluminum chloride a good coagulant for water treatment?

Polyaluminum chloride (PAC) is highly effective coagulant for water treatment over conventional coagulants because of low dosage requirement, shorter flocculation time, smaller amount of sludge, high efficiency and low aluminum residual in treated water .

What is the coagulation time for aluminum sulfate and aluminum chloride coagulants?

However, for aluminum sulfate and aluminum chloride coagulants the coagulation time and settling time were reached to 15 and 35 min, respectively. The results revealed that the residual aluminum concentration in the treated water was very small for synthesized PAC coagulant which was <0.2 mg L −1.

Do high-poly-aluminum chloride sulfate coagulants remove humic acid?

High-poly-aluminum chloride sulfate (HPACS) coagulants with different [SO42−]/ [Al3+] molar ratio (S) were prepared and proved to have high coagulation efficiency for the removal of humic acid and strong stability for storage and application. The results showed that the higher the SO42− addition, the bigger the alum

Is polyaluminium chloride better than polyelectrolyte – alum-based coagulation?

At the Barekese Water Treatment Plant in Ghana, an alternative, the polyelectrolyte – polyaluminium chloride (PAC) is also used in coagulation but limited information is available on the operating conditions required to achieve better performance than alum-based coagulation.

What is the performance of synthesized PAC compared with aluminum sulfate?

The performance of synthesized PAC compared with aluminum sulfate, aluminum chloride and commercial PAC for water treatment. 4. Conclusion The synthesis of PΑC results revealed that the low concentration of aluminum chloride favored to the formation of Αl b species of PΑC and the high concentration preferred to the formation of Αl c species of PΑC.

What is high-purity poly-aluminum chloride (PACL)?

Poly-aluminum chloride (PACl) is one of the common coagulants for water and wastewater treatment. A new Chinese national standard of PACl has been implemented, where the concentration of insoluble substances, iron and heavy metals is to be controlled strictly, then researches on the preparation of high-purity PACl are needed.