What is modified polyacrylamide drilling fluid?

Indeed, modified polyacrylamide drilling fluid has been proven to be of great interest for use in the construction of bored piles and diaphragm walls in recent years. 1. Introduction Drilling fluid is a critical component in exploration and excavation, classified into water-based, oil-based, synthetic-based, and gas-based.

Can polyacrylamide be used for drilling?

However, polyacrylamide with high molecular weight can be a good candidate at lower concentrations to meet the drilling requirements. The viscosity of polyacrylamide at all concentrations decreases with increasing temperature, according to Magzoub et al. (2021).

Does barite/polyacrylamide nanocomposite affect water-based drilling fluid?

Roodbari and Sabbaghi (2021) studied the effect of barite/polyacrylamide nanocomposite in the water-based drilling fluid, which showed the incline of its fluid viscosity and the reduction of fluid loss and filter cake thickness. Besides, Kuma et al. (2020) optimised the polyacrylamide-based drilling fluid with the inclusion of hematite.

What is the thermal conductivity of polyacrylamide based drilling fluid?

It showed thermal conductivity around 0.9 Wm −1 K −1 that have 84% improvement when compared to the bare polyacrylamide. Study of filtration and rheological properties in polyacrylamide-based drilling fluid using graphene oxide

How can alumina/polyacrylamide nanocomposite improve the viscosity of drilling fluid?

Alizadeh et al. (2015) improved the polyacrylamide by synthesising alumina/polyacrylamide nanocomposite through solution polymerisation. As a result, the viscosity of the drilling fluid was more than 300 cP for freshwater mud at 4 wt% and about 100 cP for saltwater mud at 2 wt%, respectively.

How stable is silica in polyacrylamide based drilling fluid?

Kumar et al. (2020) studied the stability of silica in polyacrylamide-based drilling fluid with the saline environment. The result revealed a maximum pH value of 8 with 2 wt% of sodium dodecyl sulphate (SDS) in that drilling fluid maintained loading up to 3 wt% NaCl.