What is cationic polyacrylamide (CPAM)?

Cationic polyacrylamide (CPAM) is one of the most frequently used flocculants with high intrinsic viscosity and charge density. This flocculant is a water-soluble acrylamide-based polymer having cationic quaternary ammonium groups .

Can cationic polyacrylamide be used in oilfield wastewater treatment?

Author to whom correspondence should be addressed. Cationic polyacrylamide (CPAM) solid particle is one of the most commonly used organic polymer flocculants in oilfield wastewater treatment, but it poses some problems, such as a slow dissolution rate and an easy formation into a “fish-eye” in the process of diluting into aqueous solution.

What is organic polymer flocculant cationic polyacrylamide (CPAM)?

The organic polymer flocculant cationic polyacrylamide (CPAM) has the characteristics of a low additive amount, good turbidity removal and water purification effect, and high COD removal efficiency, and it has become the most commonly used polymer flocculant in the oilfield wastewater treatment process [11, 12, 13, 14, 15].

How cationic polyacrylamide (PAMC) is prepared?

Flocculation and mechanism was discussed based on zeta potential and pH analysis. A novel cationic polyacrylamide (PAMC) with various cationic monomer contents were prepared by copolymerizing acrylamide (AM) and methacryloxyethyl trimethyl ammonium chloride aqueous solution (DMC) through low-pressure ultraviolet (UV) initiation.

What is the viscosity of cationic polyacrylamide emulsion?

When the polymer content was 28.10%, the apparent viscosity of the microemulsion reached more than 321 mPa·s, and its mobility was too poor to be pumped in practical applications. Liu prepared a water-in-water cationic polyacrylamide emulsion with a viscosity of 150~500 mPa·s, but its effective content was only about 15%.

Is acrylamide a cationic flocculant?

The copolymer of acrylamide (AM) and DMC is used as an effective cationic flocculant in wastewater treatment. A series of copolymers of AM and DMC (PAMC) were synthesized using different approaches. In earlier studies, γ-ray irradiation with inverse emulsion polymerization was employed to copolymerize AM and DMC .