Why is polyaluminum chloride a good coagulant for water treatment?

Polyaluminum chloride (PAC) is highly effective coagulant for water treatment over conventional coagulants because of low dosage requirement, shorter flocculation time, smaller amount of sludge, high efficiency and low aluminum residual in treated water .

Is Pac better than aluminum sulfate & aluminum chloride for removing turbidity & nom?

Moreover, the performance of synthesized PAC was also very much higher as compared with aluminum sulfate and aluminum chloride for removing turbidity and NOM from synthetic water samples. The coagulant dose and the lime required of synthesized PAC were reduced more than two folds relative to aluminum sulfate and aluminum chloride doses.

Can PAC be prepared from aluminum chloride solution?

PAC can be prepared from aluminum chloride solution with the titration of various basification agents such as calcium oxide [16, 21], sodium hydroxide [, , ] and sodium aluminate .

What is the concentration of aluminum in Pac solution?

The aluminum concentration in the PAC solution was diluted in the ranges from 5.4 to 10.8 mg L −1. The PAC solution to Ferron solution volume ratio was 10:1, which was mixed and immediately transferred to the cuvettes in the UV–vis spectrometer for absorbance measurement.

Does initial concentration of aluminum chloride affect the yield of Al B?

As observed in Fig. 1 (a–d), the effects of initial concentration of aluminum chloride, basicity ratio, reaction temperature and time curves were steep slope and curvature, which revealed that the yield of Al b content in the PΑC species was very sensitive for these factors.

Is monomeric aluminum chloride a basification agent?

In this study, monomeric aluminum chloride was used as the main raw material and calcium oxide as the basification agent. The monomeric aluminum chloride (hexahydrate form) was extracted from Ethiopian kaolinite using hydrochloric acid and its purity was >98 % .