Why is polyaluminum chloride a good coagulant for water treatment?

Polyaluminum chloride (PAC) is highly effective coagulant for water treatment over conventional coagulants because of low dosage requirement, shorter flocculation time, smaller amount of sludge, high efficiency and low aluminum residual in treated water .

What coagulants are used in drilling fluids?

Drilling fluids used in the oil industry produce a lot of effluents that require proper treatment before their disposal. Efficient coagulants/flocculants can reduce the bulk of disposed of pollutants into the hydrosphere. Polyacrylamide-based artificial polymers are efficient flocculants for industrial effluents.

Can PAC be used as coagulant for water treatment?

The ZPD value of PAC was also revealed that the flocculation tendency of PAC particles was very high in water, and the PAC could be used as coagulant for water treatment. Fig. 5.

Is Pac better than aluminum sulfate & aluminum chloride for removing turbidity & nom?

Moreover, the performance of synthesized PAC was also very much higher as compared with aluminum sulfate and aluminum chloride for removing turbidity and NOM from synthetic water samples. The coagulant dose and the lime required of synthesized PAC were reduced more than two folds relative to aluminum sulfate and aluminum chloride doses.

Can polymeric PAC be used for water treatment?

Several researchers have investigated the synthesis, of PAC and its performance for water treatment. The results shows that various polymeric species of PAC yield (Al b species) are obtained and different performance efficiencies for water treatment are reported in the literature [21, 24].

Can PAC be prepared from aluminum chloride solution?

PAC can be prepared from aluminum chloride solution with the titration of various basification agents such as calcium oxide [16, 21], sodium hydroxide [, , ] and sodium aluminate .