How to prepare high concentration polyaluminum chloride?

A novel membrane distillation concentration method was used to prepare high concentration polyaluminum chloride (PACl) with high content of Al b or Al c. 2.52 mol/L PACl 1 with 88% Al b and 2.38 mol/L PACl 2 with 61% Al c were successfully prepared.

How is polyaluminium chloride dosed?

This was dramatically improved, to over 90%, by dosing polyaluminium chloride. PAC is directly and continuously dosed from the containers in which it is delivered at a rate of about 0.1ml/m 3 of the circulation flow. (It is very important that it is not diluted with water as it will form a gel.)

What is the coagulation removal rate of polyaluminium chloride (PAC)?

Without coagulation removal rates in a single pass of a medium-rate filter were about 50%. This was dramatically improved, to over 90%, by dosing polyaluminium chloride. PAC is directly and continuously dosed from the containers in which it is delivered at a rate of about 0.1ml/m 3 of the circulation flow.

What is high-purity poly-aluminum chloride (PACL)?

Poly-aluminum chloride (PACl) is one of the common coagulants for water and wastewater treatment. A new Chinese national standard of PACl has been implemented, where the concentration of insoluble substances, iron and heavy metals is to be controlled strictly, then researches on the preparation of high–purity PACl are needed.

How should Pac be dosed in a peristaltic pump?

PAC should be dosed continuously using a peristaltic pump. All grades of PAC should be dosed at a rate of 0.1ml/m 3 of the total flow rate. PWTAG Technical Note released in February 2014 about polyaluminium chloride (PAC) dosing. Continuous coagulation with PAC is recommended by PWTAG.

What is a normal dosing rate for pwtag PAC?

PWTAG recommends a normal dosing rate of 0.1ml/m 3 of the total flow rate, which it has also described as 0.005ml/m 3 as aluminium. There are now a number of different grades of PAC with aluminium concentrations between 9.5% and 18%. The concentration of aluminium is not the only consideration when selecting a grade of PAC to use.