Why is polyaluminum chloride a good coagulant for water treatment?

Polyaluminum chloride (PAC) is highly effective coagulant for water treatment over conventional coagulants because of low dosage requirement, shorter flocculation time, smaller amount of sludge, high efficiency and low aluminum residual in treated water .

Can PAC be prepared from aluminum chloride solution?

PAC can be prepared from aluminum chloride solution with the titration of various basification agents such as calcium oxide [16, 21], sodium hydroxide [, , ] and sodium aluminate .

What is anionic Pam used for?

Anionic PAM: It is widely used in waste water treatment of chemical industry, municipal sewage treatment, such as coal washing, mineral processing, metallurgy, iron and steel industry and electronic industry. It is also used in oil industry to enhance oil recovery which is widely used.

What is the performance of synthesized PAC compared with aluminum sulfate?

The performance of synthesized PAC compared with aluminum sulfate, aluminum chloride and commercial PAC for water treatment. 4. Conclusion The synthesis of PΑC results revealed that the low concentration of aluminum chloride favored to the formation of Αl b species of PΑC and the high concentration preferred to the formation of Αl c species of PΑC.

What is the concentration of aluminum in Pac solution?

The aluminum concentration in the PAC solution was diluted in the ranges from 5.4 to 10.8 mg L −1. The PAC solution to Ferron solution volume ratio was 10:1, which was mixed and immediately transferred to the cuvettes in the UV–vis spectrometer for absorbance measurement.

Can polymeric PAC be used for water treatment?

Several researchers have investigated the synthesis, of PAC and its performance for water treatment. The results shows that various polymeric species of PAC yield (Al b species) are obtained and different performance efficiencies for water treatment are reported in the literature [21, 24].