magnetic multi-walled carbon nanotubes modified with ...

Magnetic multi-walled carbon nanotubes modified with ...

Owing to the modification of the precursor solution with PAC, the power conversion efficiency (PCE) of the perovskite solar cells has been remarkably improved from 20.02% to 22.67%. Additionally, the PAC-modified devices without encapsulation retain 80% of their initial efficiency after aging at 85 °C in the dark for 160 hours, whereas only 69% was retained for the control device.

Get Price
effect of microplastics on the coagulation mechanism of ...

Effect of Microplastics on the Coagulation Mechanism of ...

Magnetic multi-walled carbon nanotubes modified with polyaluminium chloride for removal of humic acid from aqueous Journal of Molecular Liquids ( IF 5.3) Pub Date : 2019-01-04, DOI: 10.1016/j

Get Price
understanding synergistic mechanisms of silicate decorated ...

Understanding synergistic mechanisms of silicate decorated ...

This study employed polyaluminium chloride (PAC) and polyaluminium ferric chloride (PAFC) for the phosphorus removal released during the hydration of phosphogypsum-based excess-sulphate slag cement (PESSC), as well as microstructure modification. The ...

Get Price
coagulation efficiency and removal mechanism for composite ...

Coagulation efficiency and removal mechanism for composite ...

Enhancing hydrogen-rich fuel gas production from dewatered sludge pyrolysis: The effect of hybrid conditioning with peroxyacetic acid, polyaluminium chloride, and KOH-modified activated Chemical Engineering Journal ( IF 13.3Pub Date

Get Price
constructing ag2o nanoparticle modified tio2 nanotube arrays ...

Constructing Ag2O nanoparticle modified TiO2 nanotube arrays ...

Pyrolysis is a promising technology for the disposal of sewage sludge, because it not only greatly reduces the volume of sludge but also converts it into high calorific and pollution-free clean energy, H<SUB>2</SUB>. Direct pyrolysis of raw sludge (with moisture content of about 98%) consumes a lot of energy, thus it is necessary to dewater the raw sludge before pyrolysis. However, sludge is a ...

Get Price
simultaneous enhanced phosphorus removal and hydration ...

Simultaneous enhanced phosphorus removal and hydration ...

Silver Nanoparticle-Modified 2D MOF Nanosheets for Photothermally Enhanced Silver Ion Release Antibacterial Treatment[J]. Acta Physico-Chimica Sinica, 2023, 39(7): 221104. doi: 10.3866/PKU.WHXB202211043

Get Price
simultaneous enhanced phosphorus removal and hydration ...

Simultaneous enhanced phosphorus removal and hydration ...

This study employed polyaluminium chloride (PAC) and polyaluminium ferric chloride (PAFC) for the phosphorus removal released during the hydration of phosphogypsum-based excess-sulphate slag cement (PESSC), as well as microstructure modification. The results indicated that the PESSC samples presented shorter setting times and bleeding rates with further modifier addition due to the effective ...

Get Price
understanding synergistic mechanisms of silicate decorated ...

Understanding synergistic mechanisms of silicate decorated ...

The lightly micro-polluted raw water of Yangtze River (YRW) in autumn was treated via enhanced coagulation by composite coagulants composed of polyaluminium chloride (PAC) and polydimethyldiallylammonium chloride (PDMDAAC), named PAC/PDMDAAC

Get Price

Why is polyaluminum chloride a good coagulant for water treatment?

Polyaluminum chloride (PAC) is highly effective coagulant for water treatment over conventional coagulants because of low dosage requirement, shorter flocculation time, smaller amount of sludge, high efficiency and low aluminum residual in treated water .

Is Pac better than aluminum sulfate & aluminum chloride for removing turbidity & nom?

Moreover, the performance of synthesized PAC was also very much higher as compared with aluminum sulfate and aluminum chloride for removing turbidity and NOM from synthetic water samples. The coagulant dose and the lime required of synthesized PAC were reduced more than two folds relative to aluminum sulfate and aluminum chloride doses.

Can PAC be prepared from aluminum chloride solution?

PAC can be prepared from aluminum chloride solution with the titration of various basification agents such as calcium oxide [16, 21], sodium hydroxide [, , ] and sodium aluminate .

Can polymeric PAC be used for water treatment?

Several researchers have investigated the synthesis, of PAC and its performance for water treatment. The results shows that various polymeric species of PAC yield (Al b species) are obtained and different performance efficiencies for water treatment are reported in the literature [21, 24].

What is the performance of synthesized PAC compared with aluminum sulfate?

The performance of synthesized PAC compared with aluminum sulfate, aluminum chloride and commercial PAC for water treatment. 4. Conclusion The synthesis of PΑC results revealed that the low concentration of aluminum chloride favored to the formation of Αl b species of PΑC and the high concentration preferred to the formation of Αl c species of PΑC.

What is the concentration of aluminum in Pac solution?

The aluminum concentration in the PAC solution was diluted in the ranges from 5.4 to 10.8 mg L −1. The PAC solution to Ferron solution volume ratio was 10:1, which was mixed and immediately transferred to the cuvettes in the UV–vis spectrometer for absorbance measurement.