What is polyaluminum chloride coagulant?

1. Introduction Polyaluminum chloride (PAC) coagulant has been developed and used in water and wastewater treatment since the 1980s throughout the world (Jiang, 2001). PAC is made by partial hydrolysis of acid aluminum chloride solution using a specific reactor.

Is polyaluminium chloride better than polyelectrolyte – alum-based coagulation?

At the Barekese Water Treatment Plant in Ghana, an alternative, the polyelectrolyte – polyaluminium chloride (PAC) is also used in coagulation but limited information is available on the operating conditions required to achieve better performance than alum-based coagulation.

How PACL coagulation zones are compared with alum?

The coagulation zones at various PACl dosages and solution pH values were developed and compared with those of alum. It is found that the optimal mechanism under acidic condition is charge neutralization, while alkaline condition will facilitate the coagulation of PACl.

Is there an alternative preparation procedure for polyaluminium chloride (PAC)?

An alternative preparation procedure for polyaluminium chloride (PAC), a common inorganic coagulant, is presented in this paper.

What is the optimal pH range for Pac coagulation?

The optimal pH range for PAC coagulation performance was 7.5 to 8.0. The coagulation process in conventional water treatment could be enhanced and the ensuing water pH decline reduced appreciably by applying the right dosage of polyaluminium chloride and appropriate process conditions of pH, fluid mixing speed matrix and residence time.

What is the coagulation efficiency of ALCL 3 Pac & Pac–al 13?

Jar tests were performed to test the coagulation efficiency of AlCl 3, PAC and PAC–Al 13 in treating synthetic or actual water samples. Compared with PAC and AlCl 3, PAC–Al 13 gives the best results for turbidity, humic acid and color removal, and achieves the highest charge-neutralizing ability.