What is polyaluminum chloride coagulant?

1. Introduction Polyaluminum chloride (PAC) coagulant has been developed and used in water and wastewater treatment since the 1980s throughout the world (Jiang, 2001). PAC is made by partial hydrolysis of acid aluminum chloride solution using a specific reactor.

Is polyaluminium chloride better than polyelectrolyte – alum-based coagulation?

At the Barekese Water Treatment Plant in Ghana, an alternative, the polyelectrolyte – polyaluminium chloride (PAC) is also used in coagulation but limited information is available on the operating conditions required to achieve better performance than alum-based coagulation.

What is the difference between Alum and PACL coagulation?

The restabilization zone of PACl coagulation disappears at a higher final pH value than that of alum coagulation. Moreover, the charge neutralization and sweep coagulation zones of PACl are broader in the ranges of coagulant dosage (as Al) and pH value than those of alum.

Does polyelectrolyte –polyaluminium chloride Formance improve coagulation performance in water treatment?

At the Barekese Water Treatm ent Plant in Ghana, an alternative, the polyelectrolyte –polyaluminium chloride formance than alum-based coagulation. The aim of this study was to determine the optimal coagulant dose, mixing speed and operating pH for enhanced performance in water treatment.

What is the optimal pH range for Pac coagulation?

The optimal pH range for PAC coagulation performance was 7.5 to 8.0. The coagulation process in conventional water treatment could be enhanced and the ensuing water pH decline reduced appreciably by applying the right dosage of polyaluminium chloride and appropriate process conditions of pH, fluid mixing speed matrix and residence time.

Is there an alternative preparation procedure for polyaluminium chloride (PAC)?

An alternative preparation procedure for polyaluminium chloride (PAC), a common inorganic coagulant, is presented in this paper.