Can polyaluminum chloride be used in water treatment?

In this study, synthesis and speciation of polyaluminum chloride (PAC) for application in water treatment was investigated using a colorimetric speciation method. It was possible to produce stable preparations of PAC solutions in which a relatively stable cationic polymer predominated.

Why is polyaluminum chloride a good coagulant for water treatment?

Polyaluminum chloride (PAC) is highly effective coagulant for water treatment over conventional coagulants because of low dosage requirement, shorter flocculation time, smaller amount of sludge, high efficiency and low aluminum residual in treated water .

What are the synthesis parameters of aluminum chloride hexahydrate?

The synthesis parameters were concentration of aluminum chloride hexahydrate (0.4 to 0.8 M), basicity ratio (2.0 to 2.4), reaction temperature (60 to 80 °C) and time (180 to 360 min). The performance of PΑC for water treatment was also investigated. The monomeric, medium polymeric and colloidal species of PAC were determined by Ferron test method.

Is Pac better than aluminum sulfate & aluminum chloride for removing turbidity & nom?

Moreover, the performance of synthesized PAC was also very much higher as compared with aluminum sulfate and aluminum chloride for removing turbidity and NOM from synthetic water samples. The coagulant dose and the lime required of synthesized PAC were reduced more than two folds relative to aluminum sulfate and aluminum chloride doses.

Can PAC be prepared from aluminum chloride solution?

PAC can be prepared from aluminum chloride solution with the titration of various basification agents such as calcium oxide [16, 21], sodium hydroxide [, , ] and sodium aluminate .

Can a cationic polymer predominate PAC solution?

It was possible to produce stable preparations of PAC solutions in which a relatively stable cationic polymer predominated. The mode of preparation has a dramatic effect on the composition of PAC preparation.